Note: For the original version Basslink without the AUTO OFF/ON switch and Optional Sub
Level Control, references to these items in the Connections, Applications and Controls sections
can be ignored - all other information is valid.
POWER CONNECTIONSAPPLICATIONS
Connect power to BassLink, as shown in Figure 5.Y Install a fuse holder with a 20 A fuse within 18"BassLink is equipped with four line-level (RCA)To help you plan your installation, we included
Also observe these installation tips:of the battery + terminal (see Figure 5).inputs and four speaker-level inputs. Any combina-five system applications in Figures 6 through 10
tion of line-level and speaker-level inputs may beon pages 3 through 5. For more system ideas, see
Y Use at least #12 AWG wire for the +BATT Y The REM connection requires +5 to +12 Vdcused to provide nonfading bass when connected toyour authorized Infinity car-audio dealer.
(+12 Vdc) and GND (ground) connections. Ifsignal for BassLink to turn on remotely. Mosta head unit with four outputs.
needed, use at least a #20 AWG wire for thehead units with preamp outputs provide thisNote: The applications show the optional remote
REM (remote) connection.remote voltage signal. For speaker-level appli-Figure 6. BassLink audio connections for a headSUB LEVEL control which installs under the dash-
cations, a remote connection is not required,unit with two line-level or subwoofer (RCA) outputs.board for easy in-car bass level adjustments.
Y Route all power wires through a grommet insince BassLinkOs Auto Turn-On feature will
the vehicleOs firewall. If a factory grommet issense voltage on the speaker wires to
FRONT
unavailable, install one.automatically turn on BassLink.
RREAR
PHASETURNONAUTO
L0!OFF
Y Connect a short GND wire from BassLink to theIMPORTANT:To enable BassLinkOs Auto 180!AUTO
nearest bare metal surface. For a good connec-Turn-On feature, set AUTO TURN-ON to the�RIGHT+REMOTEGAINBassLink
REARCONTROL
tion, scrape away paint from the metal surfaceAUTO position (see Figure 12 on page 6). (right side)
UNIVERSAL�LEFT+
and use a screw with a lock (star) washer.INTERFACE�RIGHT+
FRONT
�LEFT+RL
Figure 5. Power connections for BassLink.Sub Level Control
Subwoofer or
Line-Level (optional)
FRONTRREARPHASEAUTOTURNONFUSE20A
OutputsL0!OFFPOWER
FRONTRREARFUSE20ASub Level(on Source Unit) UNIVERSAL�LEFT+REAR�RIGHT+180!REMOTECONTROLGAINREMAUTOGND
AUTOControlINTERFACEFRONT�RIGHT++BATT
PHASETURNON(optional) �LEFT+SERVO
0!OFF
LPOWER
180!AUTO
�RIGHT+GAINGNDREMOTEChassis Ground
CONTROL
REAR(Bare Metal)
�LEFT+REMUNIVERSALLF SpeakerRF Speaker
INTERFACE�RIGHT+
+BATT
FRONT
SERVO
�LEFT+
Remote
BassLink Turn-On
RCA Stereo Cables
�+��++
(right side panel)(not supplied)
Source Unit
Fuse 20 A
Source Unit
18"�+�+
Battery
LR SpeakerRR Speaker
3 |